Boot Kit for dust or splash protection
These kits provide protection against light oil, dust, and water.
The boot kit consists of a flexible vinyl or silicone right angle boot and an attaching plastic bushing. It effectively shields the wire terminals from spray water, oil mist, and dust.
Please note that the boot kit is not watertight, nor intended for waterproofing.
Due to the close fit of the bushing, the boot kit achieves a protection rating of IP51. It is designed to be used on the stationary end of the Mercotac connector. The small tip of the vinyl boot can be trimmed to accommodate different wire sizes
4 x 30 + 2 x 4 Amp, 200...
4 x 30 + 2 x 4 Amp, 200 rpm, std bearing
two contact cap w/solder lugs
two contact cap w/solder lugs
6 Poles 4 x 30 + 2 x 4 Amp,...
6 Poles 4 x 30 + 2 x 4 Amp, 300 rpm, std bearing
2 X 4 Amp, 2000 rpm, std...
2 X 4 Amp, 2000 rpm, std bearing
6-pole, 2x 4A @ 4x 30A,...
6-pole, 2x 4A @ 4x 30A, 250V, 300rpm
2 X 30 Amp, 1800 rpm, std...
2 X 30 Amp, 1800 rpm, std bearing
three contact receptacle w/...
three contact receptacle w/ three 6"wires
2 x 30 + 2 x 4 Amp, 1200...
2 x 30 + 2 x 4 Amp, 1200 rpm, std bearing
2 X 4 Amp, 2000 rpm, std...
2 X 4 Amp, 2000 rpm, std bearing
430 connector cable, plug...
430 connector cable, plug assembly 12 in wires
2 X 30 Amp, 1800 rpm, std...
2 X 30 Amp, 1800 rpm, std bearing
2 X 4 Amp, 3600 rpm, std...
2 X 4 Amp, 3600 rpm, std bearing
Boot Kit for dust or splash...
Boot Kit for dust or splash protection
4 pole 2 x 4A - 2 x 30A
4 pole 2 x 4A - 2 x 30A
two contact receptacle w/...
two contact receptacle w/ two 6" wires
